Machine module
Wire EDM
Cut PCD tip and knife blanks from discs and erode finished profiles, with modelled cut times.
A design module's Stock mode panel: three PCD discs held as counted stock with a low stock threshold each, one connected to wire EDM because it requires preparation.
Demonstration data
What goes in and what comes out
What it holds
- Wire path (mm)
- Passes
- Diamond layer (mm)
- Blank width (mm)
- Blank height (mm)
- Blanks per disc
- Chart feed (mm/min)
- Pierce time (min)
Outputs
- Modelled wire time per part and per run
- Erode queue per machine
- Discs booked out of stock
- Order lines completed as they come off
How you get it
A preset installs it with its defaults, and you set your own rates.
- PCD and diamond tooling
Questions
- They are modelled from the module's erosion chart and marked as modelled.
- No. It plans, times and tracks the erode queue; programs stay on the machine's own controller.